map of site
Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37
Publications
- Category: Question answer (continued)
- Category: Wiring questions (continued)
- Is it possible to twist copper and aluminum when connecting a 12V LED strip?
- Is it possible to twist the readings from the counter?
- Is it possible to connect PVA and VVG using PPE caps?
- Is it possible to put one difavtomat into the light and sockets at once?
- Is it possible to remove the grounding in the shield (remove the jumper)?
- Is it possible to increase the power of a gas generator from 50 to 500 watts?
- Is it possible to lay several cables in one shtroba and corrugation?
- Is it possible to install podrozetniki on mounting foam?
- Is it possible to install a current transformer on a bus if the holes are different?
- Is it possible to install a switch without a neutral wire
- Is it possible to install a dimmer if LED lamps are installed?
- Is it possible to install an incandescent lamp instead of an ammeter?
- Is it possible to install an RCD 63A at the input?
- Is it possible to install the broaching box U995 UHL2 IP54 openly?
- Is it possible to install an electric meter above the door?
- Is it possible to connect an oven and other equipment to one 32A machine?
- Is it possible to shut-off load-bearing walls for an electrician?
- Indicators A, B and C blink sequentially on the NIK2301AP3 counter
- On the VAZ 2106, the voltage decreased after changing the fuse
- On the VAZ 2107, charging has disappeared and will not start - what should I do?
- To what depth should a portable grounding conductor be immersed?
- On both wires of the switch shows the phase, the lamp does not turn off
- Based on what is the calculation of the cross section of the wire?
- Two phases were applied to the single-phase meter Energomera CE-101 - what now to do?
- What is affected by the resistance of the resistors in the filter?
- What to replace the introductory bag with?
- What to look for when choosing an electric meter in an apartment with a boiler?
- Automatic input heating when power consumption is exceeded
- Extension cord heating when connecting a spotlight
- How legitimate is the unauthorized organization of the grounding circuit in Khrushchev?
- Engines do not start - what could be the reason?
- Indications on the Puma-103.1 M electric meter do not change
- I can not understand what this outlet is for?
- The need to replace wiring in the apartment
- The need to install a column when connected to networks
- Incorrectly connected meters in a new apartment
- Double-key switch does not work properly
- Incorrect fan connection with timer
- Incorrect meter connection
- No marking on VVGng cable
- No tension in the house
- No voltage in the outlet - what to do?
- There is no light in the room after one of the five lamps burns out - what should I do?
- Low voltage at half of the outlets in the apartment
- Zero in an electric bell
- Par value of machines for protecting household appliances
- Standards for the installation of backup machines in an electrical panel
- Does a smart switch need a neutral wire?
- Do I need a separate new cable to connect the electric stove
- Need a circuit to connect the pump to the float
- Do I need to output a new cable from the shield to connect the electric stove?
- Is grounding necessary if an RCD is installed on the water heater?
- Do I need to protect the cable with open wiring in the garage?
- Do I need to protect the contactor coil?
- Is it necessary to isolate the zero bus from the shield body?
- Is it necessary to change the AVVG cable 4x25 mm² with an increase in power by 9 kW?
- Do I need to change the wiring when replacing a gas stove with an induction one?
- Do I need to change the old electricity meter to a new one in the apartment?
- Do I need to change the wiring in the apartment?
- Is it necessary to change the electric meter if the consumption is 10 kW, and 5-17 A is indicated on it?
- Is it necessary to disconnect zero when connecting a three-phase generator to a single-phase network?
- Do I need to seal the machine in front of the counter?
- Is it necessary to do grounding in a private house after the stabilizer?
- Do I need to lay a separate cable for the induction panel in a new building?
- Do I need to repair the counter if the indicators are off?
- Do you need approval for bringing electricity to a private house from the panel (380V)?
- Do I need to put a difavtomat for underfloor heating on the balcony?
- Is it necessary to install an electric meter for the entire section if we live in only two rooms of the hostel?
- Cable water resistance marking
- Torn zero in the socket, took from the switch
- Combining several electricity meters in a network
- Is the removal of the electric meter to the facade mandatory?
- Is it necessary to observe the colors of the wires when assembling the shield?
- Is it mandatory to install an electric meter on the street?
- Huge meter reading
- Is floor heating dangerous if tiles in the bathroom are cracked?
- Is dust in the rosette dangerous?
- Is it dangerous to insert cardboard into the socket?
- Is it dangerous to place the AVVG cable in a pipe with water?
- Is it dangerous that the sum of the currents of group automata is greater than the input value?
- The meter near the wires melted and bursts under load
- Grounding and grounding definitions in the floor plate
- What mechanical damage should the hose protect?
- Why connect the hood in the bathroom?
- Phase voltage deviation during zero burning
- Power outage after rain
- Power outage in a private house at night - who is behind it?
- Where to get food for the outlet in the bathroom?
- Where does the voltage between zero and ground come from 140 Volts and what to do in this case?
- Where to draw the wires to connect the sconce lamp?
- The difference between three phases from one
- Evaluate the assembly scheme of the apartment shield in a new building
- Evaluate the assembly scheme of the shield in a one-room apartment
- Evaluate the wiring diagram in a private house
- Errors during installation of the switch and the socket block - knocks the machine
- Fuses and relays blow out due to overvoltage
- Moving an electricity meter to another wall in the house
- Voltage drops in winter
- Voltage drops in the apartment when connecting the refrigerator
- Power overrun due to incorrect meter connection
- Category: Wiring questions (continued)
