map of site
Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37
Publications
- Category: Question answer (continued)
- Category: Lighting Questions (continued)
- Can I connect a lamp without grounding?
- Can I connect an LED strip to a dimmer through a dimmable power supply?
- Is it possible to connect the phase to the switch, and zero to the outlet?
- Can I connect a 12V headlamp from an 18V battery?
- Can I connect a street lamp directly?
- Is it possible to connect three photo lamps to one wire?
- Is it possible to change the type of cap in a spotlight?
- Is it possible to use a ball screw in electrical wiring?
- Can I check a mercury lamp with a multimeter?
- Is it possible to make a common counter in a house for two owners?
- Is it possible to make a device to disable the motion sensor?
- Is it possible to put halogen lamps in overhead lamps?
- Is it possible to become an electrician lighting from scratch in 27 years?
- Is it possible to lengthen a 5-meter LED strip?
- Can I install 25 W lamps in the aquarium instead of 35 W?
- Is it possible to install one transformer for 20 LED lamps?
- Can I change the controller from the chandelier to another, with the same characteristics?
- LED bulbs and tape blink when the fluorescent lamp is turned off
- The power of 200 W is indicated on the LED chandelier, can this be?
- Setting up the MW10 light sensor
- The lights in the suspended ceiling do not light
- I can’t connect the switch to control the light in different rooms
- Homemade battery does not work - experiments with galvanic sources
- Energy-saving lamp does not work, how to find a capacitor?
- The two-key switch does not work correctly - what should I do?
- Non-standard lamp switching circuit from a two-key switch
- Standards for power outages in a private house
- At what time does the night rate start?
- Do I need a starter for a DNaT lamp?
- Need a wiring diagram for two LED spotlights
- Do I need to change the electric meter?
- Do I need to put a circuit breaker in front of the counter?
- Burned wires in the shield after intervention
- Designations on the Livolo touch switch
- Limit on the number of connected LED lamps to the dimmer
- One of the keys in the three-key switch does not work
- Is it dangerous if the bare wires touch each other?
- Payment of electricity according to a multi-tariff meter
- LED Strip Seedling Lighting
- Garage power outage
- Power outage for 8 days
- Differences of DRL lamps from DRV?
- Appreciate ASD LED lamp manufacturer
- Light bulb burns out due to transformer
- The light in the apartment periodically goes out
- Selection of LED drivers for CREE XM-L2 U2 LEDs
- Connect 4 LED strips to one power supply
- Connection of 6 fluorescent lamps to a plug
- Connection of two light switches for independent lamp control
- Connecting an LED night light to a wall outlet
- Connecting the LED spotlight to the driver
- Connecting LED strip through switch
- Connecting a UV lamp with a base G23
- Connecting a photo relay and a light switch to control street lighting at home
- Are the lamps used in aquariums suitable for growing seedlings?
- Linear Halogen Lamp Polarity
- Help me choose a motion sensor in the hallway
- Help me choose decorative street lighting for chimneys
- Help connect the cabinet-mirror with backlight
- One-button turn-on of lamps
- After replacing the bulb, the machine was knocked out and the switch does not work now
- Recommend a dimmer for LED lamps
- The light is constantly on and even when the switch is off
- Power consumption of 12 lamps on 35 W
- Why are LED lights blinking in pairs?
- Why do switch contacts burn out quickly when an LED strip is connected?
- Why did LED lamps burn out quickly?
- Why in a DNaT lamp with two burners only one burner burns?
- Why did the lamps stop lighting in the chandelier, even new ones?
- Why does the Ilyich’s bulb in an ordinary cartridge not light, and the LED light?
- Why are there voltage sockets on both pins?
- Why is the machine knocked out for lighting after flooding?
- Why does the machine knock out when connecting the LED strip to the switch?
- Why does the circuit breaker knock out when the chandelier is working?
- Why does the light in the apartment turn off along with the entrance lighting?
- Why doesn't the switch turn off the light?
- Why doesn't the light switch switch modes correctly?
- Why does the light go out when you turn off a separate switch that does not apply to it?
- Why does the garland squeak when turned on?
- Why is the dimmer heated?
- Why is the chandelier control unit humming?
- Why doesn't the dimmer control the brightness of the lighting?
- Why does a working chandelier not work when connected to the ceiling?
- Why is one of the 8 rounds in the new chandelier short and what can be done?
- Why is the lamp not screwed into a spotlight?
- Why do the lights to illuminate the shelf light up and go out right away?
- Why does the monitor flicker after turning on the LED lamps?
- Why do the lights flicker and the remote control does not work on the MW Light chandelier?
- Why does a mechanical timer rotate in the wrong direction?
- Why is the off LED on the balcony blinking?
- Why does the spotlight flash when the TW10 motion sensor is connected?
- Why does the light blink when the switch is turned on?
- Why does the LED lamp flash when turned on?
- Why do extra lights flash after they are connected?
- Why do incandescent lamps flash in the model of the Ostankino tower?
- Why are the lights blinking to illuminate the stairs?
- Why do LED lamps flash when the heat gun is turned on?
- Why do spotlights only flash above the kitchen table?
- Why are energy-saving lamps blinking (added another to the circuit)?
- Why are the LED lamps in the chandelier blinking?
- Category: Lighting Questions (continued)
