Why did you turn on the LED strip when the machine was knocked out and the smell sank of burn?

Hello! I bought a set of diode tapes. There is a power supply, controller, remote control and the tape itself. I glued it, turned it on to the tee, it burned for about 3 minutes. After I pressed the remote control and a pop sounded. Knocked out sockets. But it stank of a fork that included a tape. What could be?

Ask your question Answer the question
Posted: Updated: 23.11.2018 3 comments
Loading...

3 comments

  • Admin
    11/23/2018 at 09:48

    Hello! Perhaps the power supply was weak too or defective. The only thing I can advise is to buy a new one.

    To answer
  • Oleg1971
    11/23/2018 at 10:09

    need a wiring diagram

    To answer
  • Eugene
    11/23/2018 at 14:08

    here the power supply is either not working or the LED strip is short or it could rarely close inside the socket itself, but this can happen if the wiring is careless, you can turn on the machine without load if it doesn’t knock it out, then the case in the LED tape or in the power supply must be checked including smoothly raising it through latr voltage and checking the load current in the power supply circuit by the tester, it usually does not exceed 0.02 amperes

    To answer

Add a comment

Menu