How to connect a thick cable to the machine?
How to connect a wire of large cross section 10-16 square to a modular machine. In most machines, the maximum cross section is 25 square, but in reality a wire larger than 6 square is already clamped poorly. And which zero tires are used for such a section, most tires also clamp with one bolt and also the clamping force is not enough.
What does it mean “clamps badly”? Indeed, the terminals are rated at 25 mm². Do you use copper of this section? If so, then such a section is usually used for a powerful load, and on 100 + A (and not only) automatic machines go of other standard sizes with other terminal blocks, including At some "large" machines, the terminal blocks are clamped with a hexagon and quite strongly. The question is not entirely clear. Alternatively, in the electrical panel, you can make the transition to a smaller section for connection. As for tires, the same thing. How do you determine if you have enough downforce? It is as if determined by the design of the cap of the clamping screw.
Loading...