Wire connection in an electrostatic smokehouse
Hello, when assembling an electrostatic smokehouse, I ran into a problem connecting wires. The essence of the problem is this: a familiar electrician assembled a high-voltage generator based on a power supply unit and a Zhiguli ignition coil, at the output of the plus is a high-voltage wire from a candle in a car, and now I have to connect this plus to a wire with a steel section of 0.1 mm, the generator produces about 20Kam, ideally advise how to connect this BB wire with three other wires, because three wires separately, and then connect these wires to the three outputs of the wire. If there are any ways to make the connections removable, then, because the generator will only connect to the piggy bank for the duration of use, I myself am never an electrician.
Hello! What does your generator produce KAM there? The easiest way for you is to simply peel and twist 1 BB wire (it is better to solder, crimp, etc.) with 3 others the same (insulate the connection well), and solder / crimp the crocodiles to their ends, take those in insulating shrouds. And connect to the wire conclusions with crocodiles, as the author of this video did, using a ready-made (as I understand it) device:
By the way, why bark out the BB wire? It may be easier to combine your sections (wire) of the smokehouse with a wire between each other?
Loading...