Connecting a float sensor via an intermediate relay
Hello! There is a pump (for water supply) with a power of 600 W and a float sensor (maximum switched power of 50 W). It is necessary to include a float sensor in the pump circuit (for on-off when filling the tank). How to reduce the load on the sensor? I understand from some articles on your site that you can use an intermediate relay, but how to include it in this circuit is not very clear. If not difficult, explain briefly. Thanks in advance.
Loading...
The contacts of the float can be represented as a start button - the float lies the button is pressed. That is, one of the wires from the float goes to the network 220, the other goes to the contact of the coil A1. From contact A2, the wire goes to another 220 volt wire. Instead of the old connection point to the pump, you can connect the relay contacts.
Thank.