How to connect a charging station Autoenterprice?
Hello! Help me figure out the work of the 6 kW Autoeconomic Home Autoloading Station. I connected a charging station to the 220 V network. Conclusion, this is a cable with three conductors, copper, cross-section of 6 mm2. Inside the station, a 40 A difavtomat is installed. Two outputs, this is the neutral "N" and phase, and the third wire, as I understand it, is grounding. I connected everything to a separate electric panel on which the C 62 machine was installed, as I understand it at 62 A. I made several battery charges. The charge from 8 hours was reduced to 3 hours. Those. He was pleased, but for some reason he twice knocked out into a switchboard. Tell me if I did the right thing.
Loading...
Hello! All is correct. As for the machine in the shield - there is a standard rating of 63 A. Probably, the machine was marked not with C62, but with G62? If yes, then this is not the rated current, but the type of machine made by General Electric, and the rating of this machine can be less than 63 A. Look carefully at what else is written on the machine. And if the denomination is lower, then the machine probably turned off due to overload.