How to connect a lamp instead of an air conditioner?
Good afternoon. During the repair, a conclusion was made under the ceiling for the air conditioner without a switch on the wall, since it was assumed that the air conditioner was working from the remote control. During the operation of the apartment, it became apparent that there was no need for air conditioning. It was decided to connect the lamp to this wire. The question arose of how to make the switch correctly. Please advise. I enclose a photo of the wiring and the purchased lamp. Thank you so much.
Loading...
Hello! Photos did not come, can you send them in the comments? In general, the connection diagram of the lamp on the wall is as follows: determine which wire is the phase and which is zero. After that, turn off the voltage in the shield so that the wires are de-energized. The phase wire must be broken with a switch. Those. You need to take a two-wire wire 2 * 1.5 for example, conduct it from the output of the wires for the air conditioner to the place of installation of the light switch (let's just down to a height of about a meter from the floor). So, connect the phase from the air conditioner to one core of this wire, and the other end to the switch on the input terminal (can be marked IN). This will be the incoming phase to the switch, and connect the remaining wire to the output of the switch, and the other end to the lamp to terminal L. And the second wire to connect the air conditioner, zero, that is, directly connect to the lamp.