Dimmer for LED backlight does not respond correctly to remote control commands
Good afternoon! The LED strip is connected correctly, the power supply with a margin, two dimmers, two tapes of four meters are connected to the dimmers. When assembling on the table, everything worked; when mounted on the ceiling, dimmers do not receive a signal from the remote control. The ribbons just glow when the light is on. When you press the power button on the remote control, the tapes begin to flash a little. When you turn it on again, through the switch, and press the light brightness control button, the tape blinks quickly and then simply and evenly burns to the maximum.
Tapes are laid in an aluminum profile for LED strips.
Tapes are laid in an aluminum profile for LED strips.
Good afternoon, and what control on a dimmer? Radio or infrared? If the second option, perhaps the IR receiver does not see the signal from the remote control well, in this case you need to output it so that direct visibility is ensured. If now to withdraw dimmers from the circuit does the backlight work normally?
Loading...