Installing an electric stove in the kitchen without an outlet
Good afternoon, tell me please, is it possible to install an electric stove in the kitchen if the kitchen is made of a room and there is no special outlet?
Good afternoon, tell me please, is it possible to install an electric stove in the kitchen if the kitchen is made of a room and there is no special outlet?
How to seal a hole between the floor slabs? The photo shows that we have a neighbor’s wiring there (a nine-story house of the Soviet period).
The main types of briefings on labor protection, the procedure and timing of their conduct. Who and how often conducts health and safety briefings.
What is a phase indicator, why is it needed and how to use this device. Instruction manual for the phase indicator I517M and models on signal lamps.
Dimensions and types of lugs NShVI for wires. How to crimp a single and double tip. Scope and purpose of NShVI.
The shield is in the building №1, three lamps on the street, the fourth in the building №2. It is necessary that three lamps light up from the first switch, and the fourth from the second.
What RCD ratings to put on each wiring group: light, sockets, household appliances? The total load is 110 A (52A + 26A + 32A).
Yesterday, the voltage disappeared in two outlets in the kitchen, there was light. This morning they are working again. What could be the reason?
There is no ground wire in the outlet, can I take it from the outlet for an electric stove?
I can not find the connection diagram of the GEWISS pass-through switches, two-key. How to connect this model of the light switch to the network?
Why when turning off the backlit switch, the current flows not only through the glowing diode, but also through the lamp in the ceiling? At the same time, the energy-saving light flashes.
How to install a tanning bed in an apartment? Solarium 380 V. In the apartment itself all 220 V sockets. What do you need to do to connect the solarium under 380 V?
How to calculate how many amperes to put a voltage relay on and whether to protect it before or after installation? At the input, an automatic machine is installed at 25 A.
I want to put a case with a difavtomat and connect a moisture-proof socket for the boiler from it, but I don’t know where to connect the phase, where to zero, where to earth.
After replacing the two-key light switch with a three-key one, when the third lamp is connected, the switch button does not work. What is the reason?
The computer is connected to the outlet through a power strip. If you turn on the filter and move your finger along the upper metal part, a small discharge is felt.
The neighbors flooded, the light in the bathroom and toilet disappeared (low voltage at the terminals). What to do?
The electrician says that it is necessary to put an RCD on a dishwasher, a washing machine, and an air conditioner, for a total of three! Another says, can I put one RCD on 25A?
A point of sale is opening, with a total capacity of 4 kW, mainly refrigeration equipment. Will there be enough 5 kW stabilizer and which brand to choose?
Help with collecting the switchboard in the garage. I sketched my scheme, not sure what is right. It is necessary to choose a load switch, UZO, input machines.
Hello, you need to connect the pressure switch PM / 5-3W to the pump and to the network 220. How to properly connect the relay?
How many electrical appliances can be connected to one outlet? Outlets on the wall separating the kitchen and the room. It turns out, one line of wiring.
When you disconnect the laptop from the outlet and it works on battery power, all the rules. When connected to a network, the laptop freezes, the mouse lags behind, the image is dull. What reason?
ShVVP wire 3 × 4, can I use it to connect a water heater, underfloor heating in the bathroom, oven?
We recommend reading:
How to conduct electrical wiring in an apartment - all stages of electrical installation